Vtec Solenoid Valve Removal; Installation - TOHATSU BFT250A Service Manual

dummyhead dummyhead

VTEC SOLENOID VALVE REMOVAL/

INSTALLATION

Remove the following:
– Cooling fan cover (page 5-68)
– ECM (page 10-5)
Release the VTEC solenoid valve 1P connector [1] from
the connector holder of the ECM bracket [2] and
disconnect it.
Release the harness clip [3] from the VTEC solenoid
valve wire harness.
Remove the bolt (8 x 50 mm) [4], bolts (8 x 75 mm) [5],
and VTEC solenoid valve [6].
Replace the packing [7] with a new one and install the
VTEC solenoid valve.
Install and tighten the bolt (8 x 50 mm) and bolts (8 x 75
mm).
Set the harness clip from the VTEC solenoid valve wire
harness.
Connect the VTEC solenoid valve 1P connector and set
the connector to the connector holder of the ECM
bracket.
Install the following:
– Cooling fan cover (page 5-69)
– ECM (page 10-5)
FUEL SYSTEM
[3]
[5]
[4]
[3]
[2]
[1]
[4]
[6]
[7]
5-101