TOHATSU BFT250A Service Manual page 610

dummyhead dummyhead
CONTROLS
4. Move the remote control lever fully to the "R"
(Reverse) side [1].
Return the lever to the "N" (Neutral) position [2]
slowly.
5. With the lever returned to the "N" (Neutral) position,
mark a mark on the cable outer seal end of the inner
cable (Mark (B) [3]).
6. Mark a mark at the mid point between the mark (A)
[1] and mark (B) [2] on the inner cable (Mark (C) [3]).
7. Push on the inner cable and align mark (C) [1] with
the cable outer seal end.
8. Push on the link rod [1] end lightly right and left and
check for play. If there is play in the link rod, set the
link rod at the center of the play [2].
20-4
[3]
[3]
[1] [2]
[1]
[2]
[2]
[1]
[1]