Cylinder Head Cover Removal; Installation - TOHATSU BFT250A Service Manual

dummyhead dummyhead
Install the cooling fan [1] and four bolts (6 x 16 mm) [2].
Install the following:
– Cooling fan cover (page 5-69)
– Engine cover

CYLINDER HEAD COVER REMOVAL/

INSTALLATION

REMOVAL
Disconnect the battery negative (–) cable.
Shift the remote control lever in the N (neutral) position.
Remove the following:
– Engine cover
– L./R. engine under cover (page 6-3)
– Intake manifold (page 5-72)
– Direct ignition coils (page 3-17)
Remove the fuel pump (Low pressure side) mounting
bolt A (8 x 32 mm) [1] and mounting bolt B (8 x 45 mm).
Remove the water separator bracket mounting bolt (6 x
14 mm) [3].
Remove the wire harness clip [1] and harness clamp
bolt (6 x 14 mm) [2].
Disconnect the breather tube B [3].
Remove the two harness clamp bolts (6 x 14 mm) [1]
and tube clamp bolt (6 x 14 mm) [2].
Disconnect breather tube A [3].
CYLINDER HEAD
[2]
[1]
[3]
[3]
[1]
[3]
[1]
[2]
[2]
[1]
[2]
14-19