Assembly; Propeller Shaft Holder; Disassembly/Assembly - TOHATSU BFT250A Service Manual

dummyhead dummyhead
GEAR CASE (COUNTER ROTATION)
REVERSE BEVEL GEAR NEEDLE
BEARING (28 x 39 x 30 mm)
REPLACEMENT
Remove the reverse bevel gear (page 17-25).
Drive out the needle bearing (28 x 39 x 30 mm).
Place a wood block [1] under the reverse bevel gear [2].
Apply gear oil to the outer circumference of a new
needle bearing [3].
Install the needle bearing in the reverse bevel gear
using the special tools and a hydraulic press as shown.
TOOLS:
Driver [4]
Attachment, 37 x 40 mm [5]
Pilot, 28 mm [6]

PROPELLER SHAFT HOLDER

DISASSEMBLY/ASSEMBLY

DISASSEMBLY
Remove the needle bearing (32 x 42 x 30 mm) [1] from
the propeller shaft holder [2] using the special tools and
hydraulic press.
TOOLS:
Driver, 280 mm [3]
Oil seal driver attachment,
28 x 35 mm [4]
Pilot, 32 x 50 mm [5]

ASSEMBLY

Apply gear oil to the circumference of a new needle
bearing.
Drive the needle bearing (32 x 42 x 30 mm) [1] into the
propeller shaft holder [2] using the special tools and a
hydraulic press as shown.
• Install the needle bearing with the stamped end up
(toward the special tool side).
TOOLS:
Taper bearing installer
attachment, 90 mm [3]
Attachment, 32 x 42 mm [4]
17-30
07749-0010000
07746-0010200
07JAD-PH80400
07949-3710001
07945-4150200
07MAD-PR90200
070PF-ZY3A100
070PD-ZY3A100
[4]
[5]
[3]
[6]
[3]
[5]
[3]
[4]
[1]
[2]
[1]
[4]
[2]
[1]
[2]