TOHATSU BFT250A Service Manual page 569

dummyhead dummyhead
Remove the self-locking nut (25 x 2.0 mm) [1], washer
(25 mm) [2], self-locking nut (7/8-14 UNF) [3], washer
(7/8 in) [4], and tilting shaft [5].
Remove the self-locking nut (10 mm) [6], washer (10
mm) [7], and bolt (10 x 235 mm) [8].
Remove the R. stern bracket [9] from the swivel case
and release the L. stern bracket [10] from the lower
cylinder collar [11].
Remove the lower cylinder collar and two lower cylinder
bushings [12].
Remove the two wave washers (26 mm) [13] and two
swivel case bushings [14].
Remove the two bolts (6 x 20 mm) [1] and trim angle
sensor [2].
Remove the motor cord bushing [3] from the L. stern
bracket [4].
Remove the L. stern bracket.
Remove the two E-rings [1], upper cylinder pin [2], and
two upper cylinder bushings [3], and remove the power
trim/tilt assembly [4].
[2]
[1]
[10]
[8]
[11]
[12]
[4]
[3]
[1]
[2]
TRIM/TILT
[5]
[13]
[14]
[4]
[3]
[9]
[7]
[6]
[2]
[1]
[3]
[4]
19-7