TOHATSU BFT250A Service Manual page 366

dummyhead dummyhead
ENGINE REMOVAL/INSTALLATION
Apply marine grease to the seal holder [1] O-ring
groove and bearing part.
Apply marine grease to a new O-ring (26.9 x 2.4 mm)
[2], and install it to the seal holder.
Install the seal holder on shift shaft B [3] so that shift
shaft B does not tilt on the mount case.
Install the two bolts (6 x 11 mm) [4] to the shift holder
and tighten them.
Tape [5] shift shaft B as shown.
Apply marine grease to the oil seal contact surface of
the shift shaft B.
Apply marine grease to the lip part and soapy water to
the outer circumference of a new oil seal [6], and install
the oil seal to shift shaft B so that the oil seal lip part is
toward the lower side.
Apply marine grease to the shift arm [7] click part.
After installing the seal holder, install the shift arm to
shift shaft B and tighten the washer (6 mm) [8] and bolt
(6 x 16 mm) [9].
Make sure the click roller [1] is in the shift arm groove
[2] and assist spring tip [3] is pushing the neutral switch
[4].
Make sure the assist spring tip does not contact the
neutral switch button when the shift lever is moved to
either the forward or reverse positions.
13-10
[6]
[1]
[3]
[6]
[1]
[3]
[1]
[5]
[2]
[4]
[2]
[9]
[8]
[7]
[2]
[3]
[4]