TOHATSU BFT250A Service Manual page 486

dummyhead dummyhead
GEAR CASE (STANDARD ROTATION)
PROPELLER SHAFT HOLDER
DISASSEMBLY/ASSEMBLY
DISASSEMBLY
Remove the needle bearing (32 x 42 x 30 mm) [1] from
the propeller shaft holder [2] using the special tools and
hydraulic press.
TOOLS:
Driver, 280 mm [3]
Oil seal driver attachment,
28 x 35 mm [4]
Pilot, 32 x 50 mm [5]
ASSEMBLY
Apply gear oil to the circumference of a new needle
bearing.
Drive the needle bearing (32 x 42 x 30 mm) [1] into the
propeller shaft holder [2] using the special tools and a
hydraulic press as shown.
• Install the needle bearing with the stamped end up
(toward the special tool side).
TOOLS:
Taper bearing installer
attachment, 90 mm [3]
Attachment, 32 x 42 mm [4]
VERTICAL SHAFT DISASSEMBLY/
ASSEMBLY
DISASSEMBLY
Remove the oil slinger [1] from the vertical shaft [2] by
expanding the cut in the oil slinger with a screwdriver.
16-32
07949-3710001
07945-4150200
07MAD-PR90200
070PF-ZY3A100
070PD-ZY3A100
[2]
[3]
[4]
[2]
[1]
[5]
[3]
[4]
[1]
[2]
[1]