Installation; Map Sensor Removal/Installation; Iat Sensor Removal/Installation - TOHATSU BFT250A Service Manual

dummyhead dummyhead
FUEL SYSTEM
MAP SENSOR REMOVAL/

INSTALLATION

Remove the engine cover.
Disconnect the MAP sensor 3P connector [1].
Remove the bolt (5 x 18 mm) [2], MAP sensor [3], and
wire band stay [4].
Replace the O-ring with new one [5] and coat it with
engine oil.
Install the MAP sensor and wire band stay, and tighten
the bolt to the specified torque.
TORQUE: 3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
Connect the 3P connector to the MAP sensor.
Install the engine cover.
IAT SENSOR REMOVAL/
INSTALLATION
Remove the engine cover.
Disconnect the 2P connector [1] and remove the IAT
sensor [2].
Replace the O-ring with new one [3] and coat it with
engine oil.
Install the IAT sensor to the specified torque.
TORQUE: 18 N·m (1.8 kgf·m, 13 lbf·ft)
Connect the 2P connector.
Install the engine cover.
5-98
[1]
[4]
[2]
[3]
[3]
[2]
[5]
[1]