TOHATSU BFT250A Service Manual page 315

dummyhead dummyhead
INSTALLATION
• Be careful not to press the fuel tube A with the under
case grommet A.
Connect the switch panel wire harness connector 14P
connector [1] and indicator panel wire harness 6P
connector [2], and then attach them to the connector
holders.
Set the switch panel wire harness into the crankcase
groove.
Set the two wire harness clips [1] to the harness bracket
[2].
Install the harness bracket by aligning its cutout [3] with
the crankcase boss [4].
Install and tighten the bolt (6 x 14 mm) [5].
Make sure the white mark [1] on the starter cable [2]
aligns with the edge of the front cover bracket [3].
Pass the fuel tube A [4], indicator panel wire harness
[5], starter cables [6] and switch panel wire harness [7]
through the under case grommet A [8].
OTHER ELECTRICAL
[2]
[1]
[2]
[5]
[1]
[2]
[3]
[4]
[1]
[4]
[3]
[1]
[2]
[3]
[8]
[5]
[7]
[6]
10-9