TOHATSU BFT250A Service Manual page 592

dummyhead dummyhead
TRIM/TILT
Install the power tilt motor [1] on the pump by aligning
the projection [2] on the motor with the cutout in the
drive joint [3].
Set the motor wire of the power tilt motor facing toward
the manual valve side.
Tighten the four power tilt motor mounting bolt/washers
[4] to the specified torque.
TORQUE: 4.9 N·m (0.50 kgf·m, 3.6 lbf·ft)
Apply ATF to a new O-ring [1] and install it on the
cylinder.
Install the oil tank [2] on the cylinder and tighten the
three oil tank mounting bolt/washers [3] to the specified
torque.
TORQUE: 4.9 N·m (0.50 kgf·m, 3.6 lbf·ft)
Remove the oil tank cap [1]. Pour flesh ATF to the
upper limit [2] of the oil tank filler port.
OIL CAPACITY:
0.68 liter (0.72 US qt, 0.6 Imp qt)
• Do not overfill with ATF; that will damage the oil seal
of the motor when each rod is compressed.
After filling the oil tank with ATF, bleed air from the
power tilt/trim (without mounting on the outboard motor)
(page 19-31).
Install the oil tank cap and tighten it to the specified
torque.
TORQUE: 2.5 N·m (0.25 kgf·m, 1.8 lbf·ft)
19-30
[2]
[4]
[2]
[2]
[1]
[1]
[3]
[3]
[1]