TOHATSU BFT250A Service Manual page 590

dummyhead dummyhead
TRIM/TILT
Using the special tool, tighten the left and right rod
guides [1] to the specified torque.
TOOL:
Pin wrench, 4 mm [2]
TORQUE: 140 N·m (14.3 kgf·m, 103 lbf·ft)
Apply ATF to the manual valve O-rings [1].
Install the manual valve [2] to the pump [3] and tighten it
to the specified torque.
TORQUE: 3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
Install the internal circlip [4].
Apply ATF to five new O-rings [1], valve seat O-ring [2]
and orifice collar [3].
Install the steel ball [4] into the reservoir valve [5] and
set the pin [6].
Install the reservoir valve into the cylinder.
Install the filter [7] and valve seat O-ring to the valve
seat [8].
Install the valve seat into the pump.
Install the five O-rings and orifice collar in the cylinder
and install the pump [9] on the cylinder.
Install and tighten the socket bolts A [10] and B [11] to
the specified torque.
TORQUE: 8.3 N·m (0.85 kgf·m, 6.1 lbf·ft)
Fill the pump [1] fully with fresh ATF.
Do not fill up the pump quickly. Pour ATF in the pump
slowly.
19-28
07SPA-ZW1020A
[4]
[10]
[11]
[1]
[2]
[1]
[3]
[2]
[1]
[5]
[6]
[4]
[1]
[9]
[7]
[8]
[3]
[2]