TOHATSU BFT250A Service Manual page 462

dummyhead dummyhead
GEAR CASE (STANDARD ROTATION)
GEAR CASE/EXTENSION SEPARATOR
(XXA type) REMOVAL/INSTALLATION
REMOVAL
Set the remote control lever in the "N" (Neutral)
position.
Tilt up the motor to the uppermost position.
Remove the bolt/washer (10 x 32 mm) [1], and trim tab
[2].
Remove the gear case nut (12 mm) [3] and washer (12
mm) [4].
Hold the gear case [5] and remove the six bolt/washers
LA, XA types:
(10 x 47 mm) [6] from the gear case.
Hold the gear case and remove the six nuts (10 mm) [7]
XXA type:
and six washer (10 mm) [8] from the gear case.
• When loosening the stud bolt, tighten it and check
that the length from the bolt head to the extension
case surface is within specification.
– LA and XA types: page 16-48
– XXA type: page 16-49
Disconnect the speedometer tube [9] from the gear
LA, XA types:
case.
Remove the gear case by sliding the vertical shaft [10]
down.
Disconnect the speedometer tube, and remove the
XXA type:
extension separator [11].
Remove the shift rod A [12] and two dowel pins [13].
• Joint clip [14] is fitted to the shift shaft A, so it is hard
to remove the shift rod A [15].
Take care not to apply excessive force to the shift rod
A.
Remove the two dowel pins [16] from the extension
XXA type:
separator.
After removing the gear case, tilt down the motor to the
lowermost position.
16-8
[16]
[11]
[10]
[5]
[2]
[4]
[1] [3]
[9]
[15]
[14]
[12]
[13]
[8]
[7]
[6]