TOHATSU BFT250A Service Manual page 568

dummyhead dummyhead
TRIM/TILT
POWER TRIM/TILT/SWIVEL CASE
REMOVAL/INSTALLATION
REMOVAL
Remove the mount case (page 18-4) and swivel case/
stern bracket from the boat.
Loosen the manual valve [1] fully and set the swivel
case to the uppermost position.
After raising the swivel case to the uppermost position,
secure it in the position with the tilt stopper and tighten
the manual valve to the specified torque.
TORQUE: 3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
Remove the two bolts (6 x 32 mm) [1], ground terminal
[2], and anode [3].
19-6
[1]
TO TIGHTEN TO LOOSEN
[2]
[1]
[3]