Fuel Pump (High Pressure Side)/Vapor Separator Removal/Installation - TOHATSU BFT250A Service Manual

dummyhead dummyhead
FUEL SYSTEM
Connect the fuel return hose [1] and vacuum hose [2] to
the pressure regulator [3].
Connect the 2P connectors [1] to the fuel injectors.
Clamp the main harness [2] to the tube clip [3].
Install the intake manifold (page 5-76).
FUEL PUMP (HIGH PRESSURE SIDE)/
VAPOR SEPARATOR REMOVAL/
INSTALLATION
REMOVAL
Remove the intake manifold (page 5-72).
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when
handling fuel.
• Keep heat, sparks, and flame away.
• Wipe up spills immediately.
• Handle fuel only outdoors.
Release the V tube (3.5 x 6.5 x 600 mm) [1] from the
tube clamp [2].
Loosen the vapor separator drain screw [1] and drain
the fuel in a suitable container.
After draining, tighten the drain screw to the specified
torque.
TORQUE: 1.5 N·m (0.15 kgf·m, 1.1 lbf·ft)
5-86
[2]
[3]
[3]
[1]
[2]
[2]
[1]
[1]
[1]
[1]