Installation Of Pulley And Timing Belt - TOHATSU MFS 60A Service Manual

7) Installation of Pulley and Timing Belt

Check that " " mark a of timing pulley 1 and " " mark b
1.
of cylinder block are aligned with each other.
No.1 piston is to be at top dead center of
compression stroke.
2. Install cam shaft pulley, bring "
pulley 2 to " " mark d of cylinder head, and then, tighten
bolt 3 to specified torque.
Cam Shaft Pulley Bolt 3 :
27 N·m (20 lb·ft) [ 2.7 kgf·m ]
Do not turn timing pulley or cam shaft pulley with
timing belt removed. Doing so can make pistons
and valves interfere with each other, resulting in
damages to these parts.
1342
1342
Attach timing belt 4 to timing pulley with its part number
3.
side facing upward, and then to cam shaft pulley.
• Be careful not give damage to timing belt when
installing.
• Do not twist timing belt, bring inside out, or bend
sharp, or it may be damaged.
• Be careful not to allow oil or grease to adhere to
timing belt.
4st 60 2019
I" mark c of cam shaft
CAUTION
CAUTION
b
d
2
3
a
1
2
c
5
1342 1342
1342
4
5-23