Ethernet Routing Switch 8300 Series Chassis; 8005Di Dc Power Supply - Avaya Ethernet Routing Switch 8300 Series Installation Manual

DC power supply fundamentals
In addition to the DC power supply and the installation guide, your DC power supply shipment
contains several hardware accessories. Verify that the items in the shipping container match
those on the shipment packing list.
Use the following table as a checklist to verify the contents of the DC power supply shipping
container.
Table 3: DC power supply shipping accessories
Check

Ethernet Routing Switch 8300 series chassis

This section describes the Ethernet Routing Switch 8300 series chassis DC power supplies.
The 8306 and 8310 chassis each have three power supply bays in which you can install either
the 8005DC or the 8005DI DC power supply.
If the total power provided by the power supplies falls below the switch requirement, the polling
software displays the following message on the console: "chCheckPowerUsage: One or more
cards running low on power."
To display the total power the switch uses and the total power the power supplies provide, see
Avaya Ethernet Routing Switch 8300 Performance Management, NN46200-705.
Important:
Avaya does not support installing a combination of AC-input and DC-input power supplies
in the same chassis.

8005DI DC power supply

Each 8005DI DC power supply provides 1462 W of power to the switch. The 8005DI DC power
supply does not provide any power for Power over Ethernet (PoE).
22 Installation — DC Power Supply
Accessory
3 two-hole crimp lug
terminals with
attached tubing
6 nuts
6 lock washers
2 washers
Purpose
Connect the positive
and negative power
inputs.
Connect all leads.
Connect all leads.
Connect the ground
stud.
May 2011