Configured Mac Is Not Authenticating - Avaya 5000 Series Troubleshooting Manual

Troubleshooting authentication
Procedure
1. Use the vlan config control flexible command to set the VLAN config
2. Observe no errors after execution.
Showing Spanning Tree
About this task
Display the VLANs added to the desired STG.
If the RADIUS assigned VLAN and the original VLAN are in the same STG, the EAP enabled
port is moved to RADIUS assigned VLAN after EAP authentication succeeds.
Procedure
1. Use the show spanning-tree stp <1-8> vlans command to display the
2. Identify if RADIUS assigned VLAN and original VLAN are in the same STG.
Adding RADIUS assigned VLAN to Spanning Tree Group
About this task
Configure the VLAN that was assigned by RADIUS to the required Spanning Tree Group
(STG).
Procedure
1. Use the spanning-tree stp <1-8> vlans command to make the change.
2. Review output to identify that the change was made.

Configured MAC is not authenticating

Correct a MAC to allow authentication.
92 Troubleshooting
control to flexible.
information.
Comments? infodev@avaya.com
December 2013