Adding Ports To A Hunt Group Using The Cli; Configuring Vlan Trunk Protocol (Vtp) Snooping - Avaya Cajun P550R User Manual

Chapter 4
Adding Ports to
a Hunt Group
Using the CLI

Configuring VLAN Trunk Protocol (VTP) Snooping

4-32
11. Repeat steps 1 through 10 on the switch at the other end of
the hunt group connection.
12. Select Configuration from the Modules & Ports group on the
web agent window. The Module Information dialog box re-
opens (see Figure 4-16).
13. Select a port number from the Ports column. The Physical
Port Configuration dialog box opens (see Figure 4-17).
14. Select a checkbox from the Enable column for that port. The
group can now function as a load-sharing connection.
15. Click APPLY to save your changes, or CANCEL to restore
previous settings.
* Note: If thousands of addresses have been learned on a port
and a link in the hunt group goes down, the switch-over
of traffic between ports may take several seconds.
To add ports to a hunt group using the CLI, enter the following
command from Configure mode:
> (configure)# set port huntgroup
{<mod-num>|<mod-swport-range>}
[...,{<mod-num>|<mod-swport-range>}]<huntgroup-
name>
Refer to the Cajun™ P550™/P880/P882 Command Line Interface
Reference Guide for Version 5.0 for details about this command.
VTP is a layer 2 protocol developed by Cisco to maintain VLAN
configuration consistency among its switches. VTP only runs over
trunk ports that have enabled either Cisco Inter-Switch Link (ISL) or
IEEE 802.1Q tagging. By using VTP snooping, you can allow your
Cajun switch to synchronize its VLAN configuration with that of a
Cisco switch that is running VTP in the same network.
VLAN additions, deletions, and name changes made on the
network's Cisco VTP server are automatically updated on Cajun
switches that have VTP Snooping enabled and are connected to the
Cisco VTP server. VLAN changes made on a Cajun switches are not
automatically updated on any other switch.
* Note: VTP Snooping is Disabled by default. You only need to
change VTP Snooping port settings if you want to Enable
its ability to learn VLAN changes on a Cisco VTP server.
You can configure VTP snooping using either the web agent or the
CLI
Cajun P550/P880/P882 Switch User Guide