Mpls Ldp Ip-Forwarding - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

mpls ldp ip-forwarding

[ no ] mpls ldp ip-forwarding [ { access-list | prefix-list } listName ) ] [ host-only ]
Syntax
Command introduced in JUNOSe Release 7.1.0.
Release Information
Specifies LSPs to be put into the IP routing table for forwarding plain IP traffic. The
Description
no version removes the listed LSPs or all LSPs from the IP routing table.
NOTE: This command replaces the deprecated mpls topology-driven-lsp
ip-interfaces command.
NOTE: Although the carriage return, <cr>, option is displayed when you type a
question mark (?) after entering the mpls ldp ip-forwarding command, this command
takes effect only if the access-list, host-only, or prefix-list keyword, or a combination
of them is specified. Otherwise, although the command is configured successfully
and no error is displayed, labels are not used in the IP routing table for forwarding
plain IP traffic. This behavior for this command began in JUNOSe Release 7.1.0, in
which the command was introduced.
Options
Global Configuration
Mode
1346
mpls ldp ip-forwarding
access-list Specifies that listName is an access list
prefix-list Specifies that listName is a prefix list
listName Name of access list or prefix list that specifies LSPs over which IP
interfaces are created
host-only Specifies that IP interfaces are created only over LSPs to host addresses