Vci-Range; Virtual-Switch - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

vci-range

vci-range start start-vci end end-vci;
Syntax
Hierarchy Level [edit interfaces at-fpc/pic/port unit logical-unit-number],
[edit logical-systems logical-system-name interfaces at-fpc/pic/port unit logical-unit-number]
Statement introduced in JUNOS Release 9.0.
Release Information
Range of VCI values used in ATM-to-Ethernet interworking cross-connects. VCI 0
Description
through 31 are reserved. VCI 0 through 31 should not be used.
start-vci
Options
end-vci
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics

virtual-switch

Syntax virtual-switch name bridge-domain name vlan-id [vlan-ids ];
Hierarchy Level [edit protocols oam ethernet connectivity-fault-management maintenance-domain
Statement introduced in JUNOS Release 9.6.
Release Information
Specify the routing-instance type as a virtual switch, under which bridge-domain
Description
MIPs must be enabled.
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
—Lowest number VCI in the range.
—Highest number VCI in the range.
Range: 0 through 255
Configuring ATM-to-Ethernet Interworking on page 236
domain-name default-x]
Configuring MIP for Bridge Domains of a Virtual Switch on page 706
Example: Configuring Connectivity Fault Management for a PBB Network on MX
Series Routers
Chapter 62: Summary of Interface Configuration Statements
1517
vci-range