Functions; Overview - Siemens SINAMICS SIMOTICS S200 PROFINET Operating Instructions Manual

The following information of the displayed telegrams is displayed:
Table 8-6 Telegram structure
Telegram type
List of the status words
that are transferred in
PROFIdrive
3, 5, 102, 105
Torque supplemen‐
tary telegram
750
8.9.6

Functions

8.9.6.1

Overview

Overview
In the "Functions" area, you can call the following functions via the secondary navigation of the
diagnostic view and make settings within them:
• Assign IP address
• Firmware update
• Assign PROFINET device name
• Reset PROFINET interface parameters
• Set time
Overview
To restore the converter to the delivery state, you need to reset the PROFINET interfaces of the
converter in addition to restoring the factory settings.
If the converter is connected to a controller while the PROFINET interfaces are being reset,
the controller assigns new interface parameters to the converter immediately after the reset.
To prevent this, switch the controller to "Stop" mode before the reset or terminate the
connection between controller and converter.
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
Status words
Value of the proc‐
ess data (PZD)
the telegram.
X
X
Value Format switchover
The value of the process data
is switched to a different rep‐
resentation (hex, bin, dec).
X
X
Commissioning (Startdrive)
8.9 Using online diagnostic functions
Numbering and ar‐
rangement of the
process data.
X
X
PZD
X
X
301