Table of Contents
Advertisement
8.4.2
Simple basic parameterization (offline)
Overview
The following workflow represents the simplest form of commissioning.
Requirement
None
Procedure
Proceed as follows to perform basic parameterization in offline mode:
1. Create or open a project with Startdrive.
2. Create device configuration in Startdrive offline.
– Insert and specify the SINAMICS drive in the project.
– Optional: Configure user management and make protection settings for the drive.
– Create and specify SINAMICS components.
– Make detailed settings for the drive and components.
3. Make basic settings offline via the guided quick startup.
4. Load project data to the target device.
5. Establish an online connection between Startdrive and the target device.
6. Optimize commissioning.
Result
The motor rotates.
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
8.4 Procedures for device configuration and commissioning
Commissioning (Startdrive)
231
Advertisement
Table of Contents
