Table of Contents
Advertisement
Corrective maintenance
13.2 Service and maintenance for the motor
Replacing the motor with a motor with another article number
If you are using a different motor type, after performing the three steps above, you must also
carry out the following steps:
1. Reset the converter to factory settings.
You can find more information in Section "Restoring the converter to factory settings
(Page 587)".
2. Commission the converter. You can find more information in the following sections:
"Commissioning (web server) (Page 163)"
"Commissioning (Startdrive) (Page 219)"
"Series commissioning (Page 315)"
Result
You have now replaced the motor.
604
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
Advertisement
Table of Contents
