Table of Contents
Advertisement
• Language setting
• Date and time
In the following cases it may be necessary to restore the converter to factory settings:
• Incomplete commissioning
• If the motor is changed
• If there is uncertainty regarding the previous parameterization and/or the previous use of the
converter
Requirement
• There is an online connection between the project and the drive (see Chapter "Establishing
an online connection to the converter (Page 288)").
• For activated user management (UMAC):
The function rights required for "Restore factory settings" are activated for your user account.
Details on this topic are provided in Chapter "Security settings in Startdrive" of Industrial
Cybersecurity Configuration Manual
109810578).
Procedure
Proceed as follows to restore factory settings:
1. In the secondary navigation, click on menu "Backup/Restore".
The corresponding function view opens.
2. Click the "Start" button in the "Restore factory setting" field.
Result
The converter is reset and then restarted. If the "RDY" and "COM" LEDs on the converter light up
green, resetting is complete.
More information
For a full reset of the converter, see Section "Reset of all user-defined settings to the factory
setting via an SD card (Page 587)"
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
8.9 Using online diagnostic functions
(https://support.industry.siemens.com/cs/ww/en/view/
Commissioning (Startdrive)
307
Advertisement
Table of Contents
