Siemens SINAMICS SIMOTICS S200 PROFINET Operating Instructions Manual page 802

Appendix
A.3 Parameters
p2586 EPOS jog 2 setpoint velocity
Data type: FloatingPoint32
Read permission:
Write permission:
Can be changed in the operating
state:
Parameter group:
Unit: mm/s
Min:
-4e+07 [mm/s]
Description: Sets the setpoint velocity for jog 2.
Dependency: See also: p2588, c2590, c2591
p2586 EPOS jog 2 setpoint velocity
S200 Basic PN (EPOS Data type: FloatingPoint32
Lastseite rotierend),
Read permission:
S200 PN (EPOS
Write permission:
Lastseite rotierend)
Can be changed in the operating
state:
Parameter group:
Unit: °/s
Min:
-4e+07 [°/s]
Description: Sets the setpoint velocity for jog 2.
Dependency: See also: p2588, c2590, c2591
p2587 EPOS jog 1 traversing distance
Data type: FloatingPoint32
Read permission:
Write permission:
Can be changed in the operating
state:
Parameter group:
Unit: mm
Min:
0.0000 [mm]
Description: Sets the traversing distance for incremental jog 1.
Dependency: See also: p2585, c2589, c2591
Note
Incremental jog 1 is started with c2591 = 1 signal and c2589 = 0/1 signal.
With c2589 = 0 signal, incremental jogging is interrupted.
800
Visible in: Standard display
Read drive data or acknowledge messages
Edit device configuration or drive applications
Operation
Jog
Max:
4e+07 [mm/s]
Visible in: Standard display
Read drive data or acknowledge messages
Edit device configuration or drive applications
Operation
Jog
Max:
4e+07 [°/s]
Visible in: Standard display
Read drive data or acknowledge messages
Edit device configuration or drive applications
Operation
Jog
Max:
2.1474828e+09 [mm]
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
Factory setting:
5.000 [mm/s]
Factory setting:
180.000 [°/s]
Factory setting:
1.0000 [mm]