Alarms; Explanation Of The List Of Faults And Alarms - Siemens SINAMICS SIMOTICS S200 PROFINET Operating Instructions Manual

System messages
12.3 Faults and alarms
12.3.3

Alarms

Overview
An alarm indicates that the reliable operation of the motor by the converter is at risk.
Description of function
Properties of alarms
Alarms have the following properties:
• Incoming alarms have no direct influence on the drive system.
• When the cause is eliminated, the alarm is no longer displayed.
• Alarms do not have to be acknowledged.
• Alarms are displayed as follows:
– On the converter via the LEDs
– On the SINAMICS SDI Status panel via the 6-digit 7-segment display
– In the web server
– In Startdrive
Alarm code or alarm value describe the cause of the alarm.
More information
You can find more information on alarms in Section "Overview of faults and alarms (Page 428)".
12.3.4

Explanation of the list of faults and alarms

Overview
The representation of a message includes as a maximum the information listed below.
Depending on the message, some information can be omitted.
The messages are displayed according to the following pattern:
430
You can find more information on the display of alarms in Section "Messages".
You can find more information on the display of alarms in Section "Display messages
(Page 294)".
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB