Table of Contents
Advertisement
5.2.3
Safety labels on the motor
Description
NOTICE
Damage to the encoder due to shocks
Shocks at the motor shaft extension can cause an encoder damage.
• Do not exert any shock at the shaft extension.
In the delivery state, the following two warning labels are attached to the motor. In addition,
there are three "hot surface" warning labels included in the scope of delivery. Before
mounting the motor, attach them to the motor surfaces and make sure that they are clearly
visible on all the four longitudinal sides of the motor.
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
"Hot surface" warning label
"No shocks at the shaft extension" warning label
Mounting
5.2 Motor
107
Advertisement
Table of Contents
