Table of Contents
Advertisement
4. Proceed as follows according to your selection:
– If you select "No. of PTO pulses per motor revolution", enter the number of pulses per
– If you select "Enter gear ratio", enter the gearbox ratio directly in the two input fields above
5. Save the settings in the project.
8.7.4
Configuring telegrams
8.7.4.1
Calling the telegram configuration
Overview
The "Telegram configuration" function is part of the device configuration, and is displayed in the
inspector window.
You can either call this function via the project tree or for Startdrive S drives, also via direct
links from the communication screen forms.
Information about the telegrams used in the converter is provided in "Communication
telegrams (Page 332)".
Requirement
• The converter has been completely created and specified in the device configuration.
• For activated user management (UMAC):
The function rights required to configure telegrams in the inspector window are activated for
your user role.
Details on this topic are provided in Chapter "Security settings in Startdrive" of Industrial
Cybersecurity Configuration Manual
109810578).
Procedure
1. Double-click the entry "Device configuration" in the project tree.
2. Click on the converter in the device configuration.
3. Click the entry "Telegram configuration" under "PROFINET interface [X150]" in the
"Properties" tab of the inspector window.
The settings for the telegram configuration are displayed below the respective fieldbus
interface.
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
motor revolution.
and below the fraction bar.
The resulting pulses per revolution are calculated from this entry.
(https://support.industry.siemens.com/cs/ww/en/view/
Commissioning (Startdrive)
8.7 Configuring the converter
285
Advertisement
Table of Contents
