Table of Contents
Advertisement
Mounting
5.2 Motor
Procedure
Proceed as follows to arrange cables in cable carriers:
1. Lay the cables.
– Use spacers to separate cables with different outer diameters or cables made of different
– Fill the spacers evenly to ensure that the position of cables does not change during
– Distribute cables symmetrically according to their weights and dimensions.
– Keep cables untwisted in the cable carrier.
– When inserting prefabricated cables in the cable carrier, do not pull the connector, as this
2. Move the cables.
– Lay the cables loosely in the carrier, so that the cables are free to move in particular in the
– Observe the specified minimum bending radii.
3. Fix the cables.
– Make sure that cables in the carrier are unattached and movable.
– Place cable fixings in a "dead" zone at each end, suitably far away from each end point of
124
materials.
operation.
may damage the strain relief or cable clamping.
bending radii of the carrier.
R
Bending radius on the cable carrier
the moving parts.
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
Advertisement
Table of Contents
