Diagnostics; Functions; Diagnostic Information: Infeed Unit And Drive Axes; Missing Enables - Siemens SINAMICS S120 Commissioning Manual

5.3.3.2

Diagnostics

The following diagnostics information on the connected drive device is provided in the
diagnostics view:
● General
Information on module and manufacturer
● Diagnostics status
Information on status and standard diagnostics
● PROFINET interface
– IO controller
– Ethernet address
– Ports
– Domain
You call the individual diagnostic information in the secondary navigation of the diagnostics
view.
5.3.3.3

Functions

The diagnostics view also provides important diagnostic information on the direct functions of
the drive unit. You can change the settings of these direct functions ONLINE in the
diagnostics view, as you do the settings for going online with the drive unit. You can also
configure the following functions in the diagnostics view:
● Assigning an IP address (Page 135)
● Assigning PROFINET device names (Page 136)
● Restoring factory settings (Page 140)
You call the individual functions in the secondary navigation of the diagnostics view.
5.3.4

Diagnostic information: Infeed unit and drive axes

The following information is applicable for both the infeed unit and drive axis.
5.3.4.1

Missing enables

☐
Commissioning with Startdrive
Commissioning Manual, 12/2018, 6SL3097-5AA10-0BP0
Information on the PROFINET device name
Information on the network connection and the IP parameters
Information on the two ports of the drive unit
Information on sync and MRP domain
"Drive axis > Diagnostics > Missing enable signals"
Diagnostics
5.3 Diagnostics via Startdrive
281