Table of Contents
Advertisement
Commissioning (web server)
7.4 Functions and menus
Description of function
Figure 7-16
Backup and restore
The following functions are available to back up and restore data and settings:
• Save drive data to backup file
Back up the settings to a file after commissioning.
The drive data are encrypted in the backup file if function "Drive data encryption" is activated
in the Security Wizard.
• Restore drive data from backup file
When replacing a device or for series commissioning, load the backed-up parameter settings
to the converter.
To restore drive data from an encrypted backup file, the previously defined password for
function "Drive data encryption" will be requested. For more details, see Section "Restoring
data from an encrypted backup data (Page 204)".
• Restore factory settings
The user-specific parameterization of the converter is deleted.
The following settings are retained after you restore factory settings via the web server:
– Settings of the communication interfaces
– UMAC and security data
To restore all settings, an SD card is required. For more details, see section "Reset of all user-
defined settings to the factory setting via an SD card (Page 587)"
200
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
Advertisement
Table of Contents
