Table of Contents
Advertisement
Functions
10.7 Safety Integrated (for S200 PN only)
10.7
Safety Integrated (for S200 PN only)
Risk minimization through Safety Integrated
Safety Integrated can be used to minimize the level of risk associated with machines and plants.
Machines and plants can only be operated safely in conjunction with Safety Integrated,
however, when the machine manufacturer:
• Precisely knows and observes this technical user documentation - including the
• Carefully constructs and configures the machine/plant. A careful and thorough acceptance
• Implements and validates all the measures required in accordance with the machine/plant
The use of Safety Integrated does not replace the machine/plant risk assessment carried out by
the machine manufacturer as required by the EC machinery directive.
In addition to using Safety Integrated Functions, further risk reduction measures must be
implemented.
Unexpected motor movements due to manipulated connecting cables
The manipulation of the connecting cables can cause unexpected motor movements in a
machine or plant. Particularly in machines or plants in which Safety Integrated Functions are
used to minimize risks, manipulation can result in serious personal injury or death.
• Prevent unauthorized access to the converter, for example by using a lockable control
• Protect the cables inside and outside the control cabinet against manipulation by taking one
NOTICE
Danger to life as a result of inactive Safety Integrated Functions after powering up
The Safety Integrated Functions are only activated after the system has completely powered
up. System startup is a critical operating state with increased risk. When accidents occur, this
can result in death or severe injury.
• Make sure that the machine is safe during the system start-up.
398
DANGER
documented limitations, safety information and residual risks.
test must then be performed by qualified personnel and the results documented.
risk analysis by means of the programmed and configured Safety Integrated Functions or by
other means.
WARNING
cabinet.
of the following measures:
– Sheathe the cables to the motors, encoders and sensors.
– Lay the cables in empty conduits.
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
Advertisement
Table of Contents
