Table of Contents
Advertisement
Commissioning (web server)
7.4 Functions and menus
More information
• Series commissioning:
For series commissioning, save the drive data of a source converter and transfer this data to
one or several target converters. You can find more information in Chapter "Series
commissioning (Page 315)".
• Replacing the converter without memory card:
If a converter has to be replaced, restore the drive data of a defective converter via the web
server. You can find more information in Chapter "Replacing the converter (Page 590)".
7.4.6.5
Restoring data from an encrypted backup data
Requirement
• You have an encrypted backup file of the converter on your operating unit.
• Configured drive password:
– You know the originally configured drive password with which the drive data in the
– You know the currently configured drive password.
• Rights required for active user management (UMAC):
– "Create backup or load drive data to Startdrive"
Note
Lost password
The following restrictions apply if the password is lost:
• Drive data encryption cannot be deactivated.
• The drive data cannot be restored from an encrypted backup file.
Recommendation:
• Store the password in a secure location, for example, in a password manager. Ensure that you
can access the password if needed.
Procedure
1. Call the "Backup and restore" menu.
2. Navigate to the "Restore drive data from backup file" area.
3. Use the "Click to select file, or drag and drop file here" button to select the backup file.
4. To restore the drive data, proceed as described below depending on the specific application.
This step is included in the following diagrams as step 3.
204
backup file were encrypted.
This is only applicable if the currently configured drive password deviates from the
originally configured drive password, with which the drive data in the backup file were
encrypted.
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB
Advertisement
Table of Contents
