Siemens SINAMICS SIMOTICS S200 PROFINET Operating Instructions Manual page 734

Servo drive system
Table of Contents

Advertisement

Appendix
A.3 Parameters
p0977
Save all parameters
 
Data type: Unsigned16
Read permission:
Write permission:
Can be changed in the operating
state:
Parameter group:
 
Unit: -
 
Min:
0
Description:
Retentively saves all parameters of the drive system to the non-volatile memory.
When saving, only the adjustable parameters intended to be saved are taken into account.
Value:
0:
 
1:
Dependency:
See also: p0976
NOTICE
The converter power supply may only be switched off after saving has been completed (i.e. after saving has started, wait
until the parameter again has a value of 0).
Writing to parameters is inhibited while saving.
r0979[0...30]
PROFIdrive encoder format
 
Data type: Unsigned32
Read permission:
Write permission:
Parameter group:
Unit: -
Description:
Displays the actual position encoder used according to PROFIdrive.
Index:
[0] = Header
[1] = Motor encoder type
[2] = Motor encoder resolution
[3] = Shift factor G1_XIST1
[4] = Shift factor G1_XIST2
[5] = Distinguishable revolutions motor encoder
[6...30] = Reserved
Note
Information about the individual indices can be taken from the following literature:
PROFIdrive Profile Drive Technology
r0980[0...299]
List of existing parameters 1
 
Data type: Unsigned16
Read permission:
Write permission:
Parameter group:
Unit: -
Description:
Displays the parameters that exist for this drive.
732
Visible in: Extended display
Read drive data or acknowledge messages
Edit device configuration or drive applications
Operation
Save & reset
Max:
1
Inactive
Save in non-volatile memory - Loaded at POWER ON
Visible in: Standard display
Read drive data or acknowledge messages
Edit device configuration or drive applications
System identification, Configuration
Visible in: Extended display
Read drive data or acknowledge messages
Edit device configuration or drive applications
System identification
 
Factory setting:
0
 
 
SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646752B AB

Advertisement

Table of Contents
loading

Table of Contents