Reconfiguring The Monitor; Redrawing The Screen; Network Administration Center Supervisor's User Guide Product Release 2 - Northern Telecom NAC User Manual

Procedure 2-1 (continued)
Workstation configuration
Step Installer's action and system's response
15 If you enter 1, followed by {RETURN}, the system takes you to prompts shown for
Step 9, after which the successive steps follow.
Enter 2, followed by {RETURN}, if the meridian.cfg file is already on the PC
workstation. Go to Step 16.
Enter 3, followed by {RETURN}, to return to prompts shown in Step 4, after which the
successive steps follow.
16 The Supervisor Login screen appears after a few seconds.
If the screen does not appear, press {CONTROL}{R} to redraw it.
If you want to exit Reflection 4+, press {CONTROL}{ALT}{X}. The DOS prompt
appears.

Reconfiguring the monitor

Redrawing the screen

Network Administration Center Supervisor's User Guide Product release 2

If the screen displays unusual characters or shows function keys that are not
on the keyboard, press {CONTROL}{T}. The monitor identification screen
appears and the monitor settings can be checked. This command can also
be used to change the background color of a color monitor.
If the display session is being run from a supervisor dial-up connection,
pressing {CONTROL}{T} does not change the terminal configuration. To
reconfigure the terminal for the dial-up session, log out, hang up the
connection and dial back in. When reconnected, the configuration prompt is
displayed and the new selected terminal configuration takes effect.
Due to minute power fluctuations, it is possible to lose a character in the
transmission signal from the NAC to the workstation. This can cause the
screen's columns to fall out of alignment and make the screen difficult to
read. Press {CONTROL}{R} to redraw the screen.
— end —
The NAC workstation 2-7