Table of Contents
Advertisement
PF1=Select no command
Removes the Command pop-up window from the screen.
PF2=Options
Displays a description or list of valid entries for the field.
PF2=Select no option
Removes the Destination Nodes pop-up window from the screen.
PF3=Edit field
Allows a field to be edited.
PF3=End editing
Indicates that no further editing is required to the field.
Remove=Erase field
Removes the contents of a field.
Fields
Message Destinations
Shows the destination(s) to receive the message. A maximum of 10 nodal
destinations and the NAC can be selected. To send the message to all nodes
and the NAC, use the "Broadcast" option from the [Commands] pop-up
window list.
Message Contents
Provides a location to enter the message. The message can contain a
maximum of four lines of 76 characters per line. Only alphabetic, numeric,
and punctuation characters may be used in a message.
Sending a message to one or more locations
Follow this procedure to send a message to one or more locations:
1
Move the cursor to the Message Destinations field.
2
Press [Options] to display a pop-up listing the destination nodes.
3
Select a node from the pop-up listing.
The pop-up listing disappears and the selection appear on the screen.
4
Repeat Steps 2 to 3 until all the nodes are selected.
5
Move the cursor to the Message Contents field.
6
Press [Edit field] to start the editing session.
7
Enter the message.
Network Administration Center Supervisor's User Guide Product release 2
Supervisor Messaging 17-13
Advertisement
Table of Contents
