Northern Telecom NAC User Manual page 33

Procedure 2-1
Workstation configuration
Step Installer's action and system's response
1 Press {CONTROL}{T} to begin the procedure.
2 If you have set up your PC workstation as in the "Personal computers workstations"
section, and Reflection 4+ is loaded on your PC, or if your workstation is a VT220 or
VT420, go to Step 4.
If you are configuring your system via a supervisor dial-up, the following prompt
appears.
REMINDER: If you have invoked this feature to change your terminal
configuration during an active supervisor dial-up session,
your new selection will NOT take effect. To change the
terminal configuration during an active dial-up session, you
and dial-up again to select the new
configuration.
freely select your terminal configuration now and it will
be properly activated for this dial-up session.
3 Press {ENTER}.
Network Administration Center Supervisor's User Guide Product release 2
If you are dialing in for the first time, however, you may
Please press <ENTER> to continue...
— —
continued
The NAC workstation 2-3
must log off