Ran Route Report - Northern Telecom NAC User Manual

Standard management reports 11-49

RAN Route Report

The RAN Route Report provides comprehensive information on the
recorded announcement (RAN) route utilization, regardless of the source
ACD queues.
This report is dependent on the customer running X11 Release 17, or
higher, software in the Meridian 1. This report supplements other
information about RANs. It is available regardless of the setting of the
CCR/EAR MIS option on the source Meridian MAX node.
The customer must also have RACD=YES in Meridian 1 overlay 16 for
each of the RAN routes in the source Meridian MAX node. RAN routes
that are configured with RACD=NO are not reported in Meridian MAX.
The RAN route name(s) is defined in the target Meridian MAX nodes
(using route definition) for use in RAN route reports. This report is
available for each of the standard report time frames (for example, interval,
shift, day, week, month, or period).
If a Meridian MAX node requested does not have RAN enabled (the switch
is running Release 16 or earlier), a line appears on the report's banner page
indicating the node's name, address and a message that the requested data
type is not supported. If RAN is enabled but the requested data is not in the
Meridian MAX database, a line appears in the report's banner page
indicating the node's name, address and a message that data was not
available from the node.
The key fields for the RAN Route Report are RAN Route and Base Time
Unit.
Network Administration Center Supervisor's User Guide Product release 2