Table of Contents
Advertisement
Time Restriction
Specifies the starting and ending time of the schedule. For example, the
times can be set to 9:00 to 17:00 to run the reports/change orders during
working hours.
Note: It is recommended that reports not be scheduled to print
between 00:00 and 01:00 (Meridian MAX time), since they may
interfere with the running of the Meridian MAX's end-of-day routines.
End of each Interval
Enter an asterisk (*) to run the schedule at the end of each interval. There
are 48 30-minute intervals in each day. Otherwise, leave the field blank to
indicate that it is not to be used in the schedule.
End of each Shift
Enter an asterisk (*) to run the schedule at the end of each shift. Otherwise,
leave the field blank to indicate that it is not to be used in the schedule.
Times in Schedule (hh:mm)
Enter a specific time the schedule is to be run. Any number between 00 and
23 can be entered for the hour. An asterisk(*) can be entered in place of the
hour to select every hour. For example, enter *:10 to indicate 10 minutes
past each hour. Any number, between 00 and 59, can be entered for
minutes.
Note 1: Data must be entered in at least one of the Date, Start of each
Week, Start of each Period, or Every ... fields. The schedule cannot be
executed if all of these fields are left blank.
Note 2: To remove a defined schedule, leave all the date selection
fields blank and resave the schedule.
Network Administration Center Supervisor's User Guide Product release 2
Schedule Definition 16-5
Advertisement
Table of Contents
