Table of Contents
Advertisement
12-8 Network Configuration Control
Target
Specifies the target queue(s) which can receive a call after it is overflowed
from the source queue. The targets may be local or remote (if the
networking option is enabled) and may consist of up to 10 digits. A
maximum of 20 different target queues can be assigned to each source
queue.
If the word
appears in this field, it indicates that no target queues
EMPTY
have been assigned and the NACD-DN is invalid. Otherwise, this field lists
all valid queues assigned as a target(s).
Unregistered targets are shown on the display with an "*" between the
target ID and the timer value. This flag is shown when no changes have
been made to the table. Unregistered targets are automatically retried by the
system approximately every five minutes.
To add a target to the table, move the cursor to the blank entry at the end of
the table and enter the new target number. The timer value for the new
target initially appears as 0.
To remove a target from the table, position the cursor on the target to be
removed and press [Remove target]. To remove the entire target table, all
targets must be individually removed.
Time
Specifies the number of seconds the call is to go unanswered before it is
time overflowed to the corresponding target queue. Each target queue,
assigned to a source queue, can have its own time.
Press [Sort by timer value] to reorder the target table according to the time
values. This function key appears only if a change is made to the target
table.
P0724352 Standard 1.0
November 1994
Advertisement
Table of Contents
