Table of Contents
Advertisement
17-14 Supervisor Messaging
Sending a broadcast message
P0724352 Standard 1.0
8
Press [End Editing] to end the editing session.
9
Press [Commands] to display the Commands pop-up window.
10 Select the "Send Message" command.
The Message Status pop-up window is displayed.
11 Select the status of the message from the pop-up window
The options are normal, urgent and acknowledge. After this is
completed, the system sends the message to the specified
destinations.
The node's name or ID can also be entered directly without displaying the
destination node pop-up window.
If an incorrect destination is selected, it can be re-selected by highlighting
the field containing the incorrect choice. If it cannot be re-selected because
all of the nodes have been selected, use the "Clear Destinations" command
from the Commands pop-up window. This erases all the entries and allows
the correct destinations to be selected.
Follow this procedure to send a message to all nodes:
1
Move the cursor to the Message Destinations field.
2
Press [Commands] to display the Commands pop-up window.
Select the " Broadcast " option.
3
The word, Broadcast, appears in the Message Destinations field.
Move the cursor to the Message Contents field.
4
5
Press [Edit field] to start the editing session.
6
Enter the message.
7
Press [End editing] to end the editing session.
8
Press [Commands] to display the Commands pop-up window.
9
Select the "Send Message" command.
The Message Status pop-up window is displayed.
10 Select the status of the message from the pop-up window
The options are normal, urgent and acknowledge. After this is
completed, the system sends the message.
November 1994
Advertisement
Table of Contents
