Nortel DMS-100 Series Maintenance Manual page 97

MAP commands to access REX test failures
ESA REX test
The ESA REX tests the ability of RLCM units to enter and exit ESA. The
ESA REX also tests the ability of the units to message the ESA processor
while the units are in ESA. The ESA REX test begins after the LCM REX
test is complete.
MAP commands for manual REX tests
The XLCM diagnostics provide the capability to implement a manual LCM
REX test. A manual REX test occurs through the addition of a REX or
REXCOV parameter to the TST command at the PM level of the MAP
display. Examples of this command are:
>MAPCI;MTC;PM;POST LCM <site><frame><unit>
Note: Post the LCM
>QUERYPM
Note: Displays information about the LCM node. Feature AF5898 adds
information about the LCMCOV REX test.
When the LCM is posted, manual control of scheduled LCM or LCMCOV
REX tests is set. To set the manual control of these tests, type:
>TST REX [ON] [OFF]
Note: The REX test of the posted LCM is enabled or disabled.
or
>TST COVREX [ON] [OFF]
Note: The COVREX test of the posted LCM is enabled or disabled.
To set the LCM REX tests for immediate execution, type
>TST REX NOW
Note: Performs LCM_REX_TEST on the posted LCM.
or
>TST COVREX NOW
Note: Performs LCMCOV_REX_TEST on the posted LCM.
DMS-100 Family RLCM Maintenance Manual XPM12 and up
Maintenance overview 1-81