Nortel DMS-100 Series Maintenance Manual page 335

65 List the SLM disk volume names by typing
>LV CM
and pressing the Enter key.
66 List the SLM file names into your user directory by typing
>LF volume_name
and pressing the Enter key.
where
volume_name is the name of the volume that contains the PM load files,
obtained in step 63.
67 Leave the disk utility by typing
>QUIT
and pressing the Enter key.
68
Access the PM level of the MAP display by typing
>MAPCI;MTC;PM
and pressing the Enter key.
69 Post the LCM that is controlled by the alarm and control card you have just
replaced by typing
>POST LCM site_name frame_no lcm_no
and pressing the Enter key.
where
site_name is the name of the site where the LCM is located
frame_no is the number of the frame where the LCM is located
lcm_no is the number of the LCM unit with the new FSP card
70 Load LCM unit 0 by typing
>LOADPM UNIT 0 CC
and pressing the Enter key.
DMS-100 Family RLCM Maintenance Manual XPM12 and up
Card replacement procedures 8-17
RLCE
NT0X91
(continued)