Nortel DMS-100 Series Maintenance Manual page 525

13 Post the ESA processor identified in step 5 by typing
>POST ESA esa_no
and pressing the Enter key.
where
esa_no is the number of the ESA processor
14 Load the ESA processor by typing
>LOADPM
and pressing the Enter key.
If
message "loadfile not found in
directory" is received
load passed
load failed
15 Determine the type of device on which the PM load files are located.
If load files are located on
tape
IOC disk
SLM disk
16 Locate the tape that contains the PM load files.
At the IOE frame
17 Mount the tape on a magnetic tape drive.
At the MAP display
18 Download the tape by typing
>MOUNT tape_no
and pressing the Enter key.
where
tape_no is the number of the tape drive containing the PM load files
DMS-100 Family RLCM Maintenance Manual XPM12 and up
Card replacement procedures 8-207
HIE
Do
step 15
step 33
step 36
Do
step 16
step 22
step 27
NT6X75
(continued)