Nortel DMS-100 Series Maintenance Manual page 86

1-70 Maintenance overview
indicates that you must wait until the tests are complete before a BRT restart.
This option does not affect the operation of the manual TST command at the
LCM MAP display level.
OFF The OFF parameter does not allow the office-level test to resume. A
message appears which indicates that the test is OFF. System BRTs
currently in progress can complete. This state is the default.
After the test is disabled, the test does not begin again until the ON option
enables the test. When the test is enabled, the office-level test resumes at the
point where the test turns OFF. This option does not affect the operation of
the manual TST command at the LCM MAP display level.
SUPPRESS When an LCM undergoes a system-initiated BRT, each
drawer is busied, tested, and returned to service. When these state changes
occur, the system generates a PM181 log to indicate the change. This
parameter allows you to suppress PM181 logs for an LCM that undergoes a
system BRT. The PM181 logs for an LCM that does not currently undergo a
system BRT are not suppressed. Also, SUPPRESS does not affect a manual
BRT run on a single drawer. This parameter can be issued at any time. A
message appears to indicate that the logs are suppressed.
ALLOW The ALLOW parameter allows the PM181 drawer to change logs
that the system BRT causes.
RESET The RESET parameter allows the user to restart an office-level test
as if LCMs are not tested. You must turn the test OFF before this parameter
is used. If you attempt to reset the BRT while the BRT is ON, a message
appears. This message indicates that the BRT must be OFF before RESET
can occur. This message also indicates that test that currently run must be
complete. This option can be used at any time and does not affect the
operation of a manual TST command at the LCM MAP display level.
QUERY
The QUERY parameter displays
297–8351–550 Standard 04.01 August 1999
the current ON/OFF status of the office-level test
the number of LCM-level tests currently in progress
the next LCM to be tested in the scheduled BRT in the format of HOST
00 0 0
the status of the SUPPRESS/ALLOW commands