Nortel DMS-100 Series Maintenance Manual page 568

8-250 Card replacement procedures
NTMX45
HIE
(continued)
8
9
10
11
12
At the MAP terminal
13
297–8351–550 Standard 04.01 August 1999
Use the following table to determine the next step in this procedure.
If you entered this procedure
from
an alarm clearing procedure
other
Load the ESA processor by typing
>LOADPM
and pressing the Enter key.
If the load
message "loadfile not found in
directory" is received
load passes
load fails
Determine the type of device on which the PM load files are located.
If load files are located on
tape
IOC disk
SLM disk
Locate the tape that contains the PM load files.
Mount the tape on a magnetic tape drive.
Download the tape by typing
>MOUNT tape_no
and pressing the Enter key.
where
tape_no is the number of the tape drive containing the PM load files
Do
step 34
step 9
Do
step 10
step 28
step 35
Do
step 11
step 17
step 22