Example Performance Test Using Iperf3; Configure The Ping Responder Service - Digi IX30 User Manual

Services
Repeat this step to include additional firewall zones.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Example performance test using iPerf3

On a remote host with iPerf3 installed, enter the following command:
$ iperf3 -c device_ip
where device_ip is the IP address of the IX30 device. For example:
$ iperf3 -c 192.168.2.1
Connecting to host 192.168.2.1, port 5201
[ 4] local 192.168.3.100 port 54934 connected to 192.168.1.1 port 5201
[ ID] Interval
[ 4] 0.00-1.00
[ 4] 1.00-2.00
[ 4] 2.00-3.00
[ 4] 3.00-4.00
[ 4] 4.00-5.00
[ 4] 5.00-6.00
[ 4] 6.00-7.00
[ 4] 7.00-8.00
[ 4] 8.00-9.00
[ 4] 9.00-10.00
- - - - - - - - - - - - - - - - - - - - - - - - -
[ ID] Interval
[ 4] 0.00-10.00
[ 4] 0.00-10.00
iperf Done.
$

Configure the ping responder service

Your IX30 device's ping responder service replies to ICMP and ICMPv6 echo requests. The service is
enabled by default. You can disable the service, or you can configure the service to use an access
control list to limit the service to specified IP address, interfaces, and/or zones.
To enable the iPerf3 server:

Web
IX30 User Guide
loopback
setup
(config)>
Transfer
sec 26.7 MBytes
sec 28.4 MBytes
sec 29.8 MBytes
sec 31.2 MBytes
sec 32.1 MBytes
sec 32.5 MBytes
sec 33.9 MBytes
sec 33.7 MBytes
sec 33.5 MBytes
sec 33.2 MBytes
Transfer
sec 315 MBytes
sec 313 MBytes
Configure the ping responder service
Bandwidth Retr
224 Mbits/sec 8
238 Mbits/sec 29
250 Mbits/sec 0
262 Mbits/sec 0
269 Mbits/sec 0
273 Mbits/sec 0
284 Mbits/sec 0
282 Mbits/sec 0
281 Mbits/sec 0
279 Mbits/sec 0
Bandwidth Retr
264 Mbits/sec 37
262 Mbits/sec
Cwnd
2.68 MBytes
1.39 MBytes
1.46 MBytes
1.52 MBytes
1.56 MBytes
1.58 MBytes
1.60 MBytes
1.60 MBytes
1.60 MBytes
1.60 MBytes
sender
receiver
618