Rotax 912 i Series Maintenance Manual page 205

Fig. 42
1. M6x20 Allen screw
3. Coolant elbow
- Install the coolant hose as far as the mark on
the coolant elbow. See also section 75-00-00
Cooling system.
- Install the spring type hose clip 25 using
spring clamp pliers part no. 877840.
Fig. 43
1. Coolant elbow
3. Coolant hose
- Install the airbox on the ignition housing using
an M6 hex. nut and 6.4 washer.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
2. 6.4 washer
4. Elbow flange
2. Spring type hose clip 25
Fig. 44
1. Airbox
3. 6.4 washer
- Install the spark plugs and connect the
resistance spark plug connectors. See also
section 74-20-00 Distribution.
- Install the temperature sensor and connect
the wiring harness. To do this, see section 76-
70-00 Sensors and actuators.
Fig. 45
1. Temperature sensor 2. M6x20 hex./torx collar screw
3. Resistance spark 4. Insulating flange
plug connector
- Install the fuel line assy. To do this, see sec-
tion 73-10-00 Fuel pump and distribution.
- Install the exhaust system. See also section
78-00-00 Exhaust.
2. M6 hex. nut
72-30-00
Page 27
July 01/2012