Rotax 912 i Series Maintenance Manual page 381

Fig. 10
1. Exhaust flange
3. Exhaust pipe
TEMPERATURE SENSOR (OTS) -
REMOVAL
Installation position: Crankcase
See Fig. 11.
Step
1 Cut open the cable ties.
2 Unplug the respective connector of the
wiring harness (main strand) from the cor-
responding temperature sensor. See also
section 76-50-00 Wiring harness (main
strand).
3 Lift the latch and pull out the connector.
Fig. 11
1. Temperature sensor
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
2. Temperature sensor
Procedure
2. Cable ties
Step
4 Use an SW19 open-ended spanner
part no. 876130 (or a similar tool) to re-
move the temperature sensor from the
crankcase.
5 Close the bore with the appropriate pro-
tective covering.
TEMPERATURE SENSOR (CTS) -
REMOVAL
Installation position: Cylinder head (cylinder 4)
Step
1 Unplug the respective connector of the
wiring harness from the corresponding
temperature sensor. See also section 76-
50-00 Wiring harness (main strand).
Step
2 Use an SW19 open-ended spanner
part no. 876130 (or a similar tool) to re-
move the temperature sensor from the
cylinder head.
Fig. 12
1. Temperature sensor
KNOCK SENSOR - REMOVAL
Preparation
- Remove the fuel line assy. See also section
73-10-00 Fuel system.
- Unplug EGT 1/3. See also section 76-50-00
Wiring harness.
Procedure
Procedure
Procedure
76-70-00
Page 11
July 01/2012