Rotax 912 i Series Maintenance Manual page 426

ASSEMBLY
OIL PUMP - ASSEMBLY
Whenever the ignition housing is ins-
NOTE:
talled or assembled, new acid-free grea-
sed o-rings and other sealing elements
must always be used correctly!
Step
1 Apply Klueber grease to the plug screw.
2 Screw the plug screw with the pressure
spring and the regulator piston finger-tight
into the oil pump housing.
Fig. 15
1. Plug screw 2. Pressure spring DM9.1 D1.0 L65.6
3. Regulator piston
Step
3 Stick insulating tape over the feather key
groove.
NOTICE
WARNUNG
Press in the oil seal so that the closed side
points towards the oil pump housing.
Step
4 Apply Klueber grease to the oil pump
shaft and push oil seal A 14x22x4 onto
the oil pump shaft while turning slightly.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
Procedure
Procedure
Fig. 16
1. Oil pump shaft
3. Oil seal A 14x22x4
Step
5 Place the oil pump housing on a firm sur-
face.
6 Remove the insulating tape from the oil
pump shaft.
7 Insert the oil pump shaft with the oil seal
and press it in as far as it will go with a
soft-faced hammer.
Fig. 17
1. Oil pump shaft
3. Oil pump housing
NOTICE
WARNUNG
The oil pump shaft must not be pulled out again,
otherwise the oil seal is unusable.
2. Insulating tape
Procedure
2. Oil seal
4. Soft-faced hammer
79-00-00
Page 14
July 01/2012